Your shopping cart is empty.
Boiler Water Treatment AUTOTREAT Boiler Water Treatment Chemical:
Boilers are critical equipment in marine and industrial operations, and maintaining proper water quality is essential for efficient performance and long service life. Poor boiler water treatment can lead to scale formation, corrosion, sludge buildup, and reduced heat transfer efficiency. AUTOTREAT Boiler Water Treatment Chemical is specially formulated to provide complete protection for boiler systems.
Autotreat is a boiler water conditioner designed for optimum protection of ships boiler systems when used in conjunction with Oxygen Scavenger Plus. The product combines well known phosphate treatment with new polymer technology. This ensures that precipitates are kept soft and no adherent for easy removal by blow down. The product should always be used in conjunction with an oxygen scavenger, preferably RXSOL Oxygen Scavenger Plus. Note that this product is formulated for use in conjunction with good quality feed water.
Boiler Water Treatment AUTOTREAT is a multi-functional boiler water treatment chemical designed to control alkalinity, corrosion, scale formation, and sludge deposition in boiler systems. Its advanced formulation helps maintain clean boiler internals, ensuring safe and efficient operation.
It is widely used in:
Marine boilers
Industrial steam boilers
Heating systems
Auxiliary boilers
Closed water circulation systems
Untreated boiler water can cause:
Scale formation that reduces heat transfer
Corrosion leading to metal damage and leaks
Sludge accumulation causing blockages
Fuel wastage due to poor efficiency
Boiler downtime and expensive repairs
Using a quality boiler treatment chemical like AUTOTREAT helps avoid these problems.
The product should preferably be dosed continuously with a Rxsol Boiler Water Treatment Dosing Unit. Alternatively the product can be fed into the feed line by means of a by-pass pot feeder.
Dosage and control
Minimum dosage is 1.2 liters of Autotreat/ton of boiler capacity to reach a P-Alkalinity level of 100 ppm. For an untreated system it is recommended to initially bring the treatment up to a suitable level of 200 ppm p-Alkalinity. The dosage chart given below is for convenience to determine the amount of product required to elevate P-Alkalinity. Note that the table is based on reaching 200 ppm. P-Alkalinity.
Sampling and testing
A representative sample of boiler water should be drawn for analysis daily. The sample should always be taken from the same point after blow down, cooled and tested immediately. Follow the Spectrapak Test Kit instructions and log the results. It is important that regular testing is carried out to ensure that treatment levels are correct.
Boiler Water Treatment AUTOTREAT controls hardness salts and prevents scale buildup inside boiler tubes.
Protects boiler metal surfaces against oxygen and acidic corrosion.
Helps maintain the proper pH and alkalinity level for efficient boiler operation.
Conditions suspended solids for easy removal during blowdown.
Keeps heat transfer surfaces clean for better fuel economy.
Regular use helps prolong the lifespan of boiler systems.
Marine boiler water treatment
Industrial boiler maintenance
Steam generation systems
Auxiliary boiler protection
Closed-loop heating systems
Test boiler water parameters.
Dose Boiler Water Treatment AUTOTREAT directly into the boiler feed system.
Maintain recommended alkalinity and pH levels.
Perform regular blowdown to remove sludge.
Monitor water quality for best results.
Dosage depends on boiler capacity and water conditions.